FREE SHIPPING ON ORDERS OVER $100

Doors


Preparation to installation



Remove the door trim panels. Don’t remove the lock and the window lift mechanism, they won’t hinder installation.


Clean the surfaces of dirt and the factory-installed sound damper, if it peels off and can be removed.

Installation


FIRST LAYER – VIBRO-DEADENING

Install the vibration-damping material STP Aero as the first layer. It is a 2,3 mm thick mastic material for damping vibration on the external metal coating.
To install the first layer, you have to measure the size. You can use a ruler or a tape line. It’s better to leave some spare areas near stiffeners, thus you can roll the material down firmly. All the parts of the material must be rolled down.


SECOND LAYER – SOUND ABSORPTION

Apply AeroFlex 6 mm with adhesive base as a second layer. It’s an effective sound-absorbing and heat-insulating material. Cut it the same size as the vibration damper, take the protective film off, and apply STP AeroFlex over STP Aero.

You don’t have to roll it down with a roller, it’ll be enough just to press it firmly with a hand.


MANUFACTURING HOLES

Initially, there is a factory-installed material on the door, which covered manufacturing holes. You should replace it with the vibration-damping material– STP Aero. Apart from its main function – vibration damping – STP Aero will also serve as a vapour-proof and water-proof material. Upon applying, we have to roll the material down with a roller.


DOOR TRIM PANEL

Proceed to the door trim panels. Here use the 10 mm thick STP Biplast. Initially there was a factory-installed sound proofing material on the plastic panel, take it off. STP Biplast is a sound-absorption and heat-insulating material.
Social Proof
x
x